Filter
Top Products
9GB
CARE AND CLEANING
Before cleaning your cooker hood or carry out any
maintenance, switch the omnipolar switch to
OFF to disconnect the hood from the electricity
supply.
CLEANING METAL GREASE FILTERS
The filters must be cleaned every 2 months of
operation, or more frequently with heavy usage,
and can be washed in a dishwasher.
• Remove the filters one at a time by pushing
them towards the back and pulling down at the
same time.
• Wash the filters, taking care not to bend them.
Allow them to dry thoroughly before refitting.
• When refitting the filters, make sure that the
handle is visible on the outside.
NOTE: After every 30 hours of use, the microprocessor which is the heart of the system, indicates
with a flashing letter ‘A’ on the display that the metal grease filters should be cleaned. Cleaning the
filters reduces the fire risk and improves the performance and efficiency of your cooker hood.
Clean the metal grease filters, following instructions in the ‘Care and Cleaning’ section.
After cleaning cancel the warning message as follows:
• Switch off the hood.
• Press and hold Key 2 for more than 5 seconds.
When the key is pressed the letter ‘A’ will
appear on the display, after the 5 seconds the
letter disappears and the microprocessor starts
a new 30 hour count down to the next warning
message.