Hotpoint RF725GP Range User Manual


 
Oven Control, Clock and Timer
Clock
The
clock
must be set
to
the
correct time
of day for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a TIME
BAKE or CLEAN cycle.
To Set the Clock
Step 1. Press the CLOCK pad.
Step 2. Press INCREASE or
DECREASE
pad
to set the time
Of
day.
Power Outage?
After
a
power outage, when power
is restored, the display will
tlash
and time shown will no longer be
correct-for example, after a
5-minute power interruption the
clock
will be 5 minutes slow.
Display
flashes
until
clock
is reset.
All other functions that were in
operation when the power went out
will have to be programmed again.
Timer
The timer does not control oven
operations. The maximum setting
on the timer is
9
hours
and
55
minutes.
To Set the Timer
Step 1. Press the TIMER pad.
Step 2. Press INCREASE or
DECREASE pad to set the amount
of
time on timer.
The timer will start automatically
within a few seconds
of releasing
the pad. The timer, as you are
setting it,
will
display seconds
unti’
60 seconds is reached. Then it will
display minutes and seconds until
60 minutes is reached.
After 60 minutes, it will display
hours
(“HR”
now appears in
display) and minutes
until
the
maximum time of 9 hours and
55 minutes is reached.
To Reset Timer
Press TIMER pad and then press
INCREASE or DECREASE pad
until desired time is reached.
To Cancel Timer
Press TIMER pad until the word
“TIMER” quits flashing on the
display (about 4 seconds).
Timer Tones
The timer tone is 3 beeps followed
by 1 beep every 6 seconds. If you
would like to remove the one beep
every 6 seconds, press and hold
CLEAWOFF for 10 seconds.
To return the tone of
1
beep every
six seconds, press and hold
CLEAWOFF for 10 seconds.
Display Messages
If “door” appears on the display,
the oven door is opened and
needs
to be closed. If “LOCK” appears
on the display, the oven door is in
the locked position. BAKE, BROIL
and COOK TIME cannot be set if
the door is in the locked position.
13