Filter
Top Products
operating
the
Self-Cleafing
Oven
(continued)
How to Delay Start
of Cleaning
Delay
Start is setting the oven
timer
to start
the
clean cycle
tiutomatically
at
a
later
time than
the
present time of day.
NOTI;:
Before
beginning make
sure
the oven
clock
shows the
correct time
of
day.
Quick Reminder—Delay Start
for Self-Clean:
1.
Prepare oven for cleaning.
2. Press CLEAN pad.
3. Press INCREASE pad.
4. Press STOP TIME pad.
Time that appears is 3 hours
later
than the time of day. Press
INCREASE
pad
until the Stop
Time you desire appears in
the display. The self-clean
cycle
will automatically begin
3
hours before the stop time
you select.
For example: Let’s say it’s
7:00
and you want the oven to begin
self-cleaning
at
9:00
after you’re
Step
4: Press INCREASE pad.
Three hours cleaning time is
automatically set.
Step
5: If a longer or shorter Clean
Time is desired, press INCREASE
or DECREASE pad until desired
Clean Time is displayed.
Step 6: Press STOP TIME pad.
“10:00”
appears on display and
“STOP TIME” flashes. The control
automatically sets Stop Time by
adding the Clean Time to the time
of day. In this example, the time of
day is
7:00
and the Clean Time is 3
hours. Adding 3 hours to the time
of day equals
10:00.
finished in the kitchen.
The
oven is
just soiled
a
normal amount so the
normal
Clean
Time of 3 hours
~
A
is preferred.
Step 1: Prepare the oven
for
cleaning.
Ste~
7:
Change
Stou
Time from
Step
2:
Close the oven door. Make
10:60
to
12:Ob
by
p~essing
INCREASE pad until “
12:00’7
sure the oven light is off.
appears in the display. The words
“DELAY CLEAN” will also
-
appear in the display.
i
The self-clean cycle will
automatically begin at
9:()()
and
finish at
12:00.
The word “ON”
will appear on the display
at
9:()().
When the oven
heats
to
a
high
temperature, the word “LOCK”
will be displayed. It will not be
possible to open the oven door
until the temperature drops below
the lock temperature.
When the clean cycle is finished,
the word “CLEAN” will go out in
the display and the oven will begin
to cool. When the oven
temperature has fallen below the
locking temperature (about 20-30”
minutes after the word “CLEAN”
goes out
at
the end of the
clean
cycle), the word “LOCK” goes out
and the door can be opened.
Step 8: When the LOCK light is
off open the door.
After a Clean Cycle
After a clean cycle, you may
notice some white ash in the
oven.
Just wipe it up with a damp cloth.
If white spots remain, remove
them with
a
soap-filled steel wool
pad. Be sure to rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt
residue that cannot be removed by
the
clean
cycle.
If the oven is not clean after one
clean cycle, the cycle may
be repeated.
Step 3: Press CLEAN pad.
26