Filter
Top Products
The Problem Solver
(continued,
PROBLEM
OVEN WILL NOT
SELF-CLEAN
OVEN DOOR WILL
NOT OPEN
A~ER
SELF-CLEAN CYCLE
CONTROL BEEPS
AFTER ENTERING
OVEN TIME OR
STOP TIME
“F-” AND A NUMBER
FLASH ON DISPLAY
POSSIBLE CAUSE AND REMEDY
● Oven temperature is too high to set self-clean operation. A11ow the oven to cool
and reset the controls.
● Oven must cool below locking temperature (approximately 30 minutes after the
clean cycle is complete).
● This is reminding you to enter a bake temperature.
● If the time display flashes “F-” and a number, you have function error code.
Press the
CLEAWOFF pad. Allow oven to cool for one hour. If the failure code
repeats, disconnect all power to the range. Call for service.
30