Hotpoint RGB52yGEP Range User Manual


 
—..
Lighting Instructions for
standing Blot ModeEs
These ranges have standingoven
pilotsthat m~st be lit initially.
To light the oven pilot:
1. Be sure OVEN CONTROL
knob is in the 0~ position.
2. Openthebroilerdoorandremove
thebroilerpanand rack.Thiswill
makeiteasierforyou toreachinside
thebroilercompfilent.
3. Find the oven pilot port at the
back of the broiler compartment.
The long tube, running from front
to back, is the oven burner, The
pilot port is at the back, about one
inch below the burner.
4. Using a long
matchormatch
holder, reach in and light the
oven pilot.
To
lightthe ovenburner:
Turn the OVEN CONTROL knob
to the desired temperature.The
burner shouldlightwithin 60
seconds.
Proper flame configuration:
While using the oven burner,
visually check theburner flame in
the broiler compartment.If flame
does not burn as describedin the
Installation sectionof thisbook,
adjust the flame followingthe
directions on those pages.
Power fai~ure?An electrical
power failure will not affect a
lighted standing oven pilot.
Lighting Instructions for
Electric Ignition Models
The oven and broil burner
on these ranges is lighted by
electric ignition.
To light the burner,turn the
OVENCONTROLknobto the
desiredtemperature.Theburner
shouldlightwithin30-90seconds.
Power outage
CAUTION:DONOTMAKE
ANYATTEMPTTO
OPERATETHEELECTRIC
IGNITIONOVENDURING
ANELECTRICALPOWER
FAILURE.Theovenor broiler
(on modelsso equipped)cannot
be litduringa powerfailure.
Gas willnotflowunlessthe
glowbar is hot.
If theovenis in usewhena
powerfailureoccurs,theoven
burnershutsoffandcannotbe
re-lituntilpowerisrestored.
Youroven is controlledby an
OVEN CONTROL knob.
It will normally take 30-90
secondsbefore the flame comes
b:
on. After the oven reachesthe
x
&s
selectedtemperature, theoven
..
-.
burner cycles-off completely,
then on with a full flame-to
maintain the selectedtemperature.
oven Light ~
(on somemodels)
The oven lightcomes on
automaticallywhen the door
is opened. On some modelsthere
._
is a manual on/offswitch to the
left of the surfaceburner controls.
M
e:
‘e
. /.:.
,{J
L ~.-.,
__._,_. . .
..”, . ...-_ . ...,, ....
-..4.
.,--T .. --..=--- -—-
—.
.—.—
——..—.—..