hussman MAXI-140 Freezer User Manual


 
©2007 HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
U.S. & CANADA 1-800-504-4828 • WWW.CHILLCHAMBER.HUSSMANN.COM
14
P/N 31033596_B
01 June 2007
MAXI-140
OPERATING TIPS
• The unit must be allowed to stand in place for
30 minutes before it is plugged in.
• Once the unit is running, the real time clock
must be set. Once fully charged, the real time
clock’s battery will keep the clock memory for
at least one week.
• In the event of power loss, the real time clock
will keep its settings for at least one week once
the battery is fully charged. The real time clock
battery is rechargeable.
• The unit should run for 30 minutes empty
and must be within 2 degrees of 22 °F before
any product is loaded inside.
• The unit must go into defrost mode twice a
day to maintain optimal performance. During
defrost, the temperature display may move up
2 or 3°F (1 to 1.5°C). Avoid opening the door
during the defrost cycle.
• If the unit is placed in a location that is not
air conditioned or has high ambient humidity,
additional defrost cycles may be required to
prevent the rear refrigeration coil from
blocking with ice.
• Very frequent door openings will eventually
have an impact on product temperature and
cause it to rise. Avoid holding the door open
while deciding on product selection, counting
inventory, etc.
• The large blue LED display above the door
simulates the average temperature of the beer in
the cooler, not the air temperature in the unit.
Therefore, the display temperature will change
slowly as the unit cools down or warms up.
• Unplug the unit before cleaning. Clean the
unit frequently to minimize odors and to main-
tain operating efficiency.
• Do not add warm product.
• Restocked product may freeze.
• Never place product on the bottom of unit.
• Place the lower removable shelf flush against
the back to maintain proper air flow and
product temperature.
• The unit must remain upright at all times.
Do not tilt more than 30 degrees from vertical
at any time.
• The light switch is located on the top right
side of the interior back wall.
• Maintain air flow around the unit at all times.
To obtain warranty information
or other support, contact your
Hussmann representative
1-800-504-4828.
Please include the model and
serial number of the product.
Or go to
http://chillchamber.hussmann.com/
serv/warranty.htm
http://chillchamber.hussmann.com/
serv/ChillChamberWarranty.pdf