Filter
Top Products
Component Replacement ICEU060
Page 16
Spray Platform
1. Unplug the icemaker to disconnect electrical power.
2. Open ice bin door.
3. Pull out on the left side and remove curtain assembly.
4. Lift the spray platform up and pull out to get to the water hose at the base of the platform.
5. Pull hose off of connection to spray platform, and pull platform from the icemaker.
6. To replace, reverse the removal procedures.
Inlet Water Valve
1. Unplug the icemaker to disconnect electrical power.
2. Shut off water supply to icemaker.
3. Remove the lower back panel, pull out to expose inlet
water valve.
4. Disconnect electrical wires from the inlet water valve.
5. Disconnect water lines to and from the water valve
6. Remove the valve from the icemaker.
7. Reverse removal procedure to replace.
Water Pump
1. Disconnect the electrical wires from the cube size control.
2. Remove the top panel,
3. Open ice bin door, pull up from the top and remove.
4. Remove curtain by pulling forward and out on the left end.
5. Remove 2 screws holding pump bracket to right side panel.
6. Disconnect 2 electrical leads and 1 ground wire from the pump.
7. Pull out spray platform, lift pump and disconnect hose.
8. Pull water pump up and out of icemaker.
9. Dismount water pump from cover assembly (retaining brackets), and remount the replacement pump in
its place.
10. Reverse removal procedures to replace.