Filter
Top Products
Troubleshooting IOD150, IOD200, IOD250
IMPORTANT: only qualified personnel should service internal components or electrical wiring.
Should the dispenser fail to operate properly, check that there is power to the unit and that the hopper
contains ice. If the unit does not dispense, check the following chart under the appropriate symptoms
to aid in locating the defect.
TROUBLE PROBABLE CAUSE
Blown fuse or circuit breaker.
A. Short circuit in wiring.
B. Defective gate solenoid.
C. Defective Agitator
Gate does not open, Agitator does not turn.
A. No power.
B. Bent depressor plate (does not actuate switch)
C. Defective dispensing switch.
Gate does not open, or is sluggish. Agitator turns.
A Stuck or bent dispenser plate. (does not release ice)
B. Excessive pressure against gate slide.
C. Defective rectifier.
Ice Dispenses Continually
A. Stuck or bent depressor plate. (does not release switch)
B. Defective dispensing switch.
C. Improper switch installation.
Slushy Ice. Water in Hopper
A. Blocked drain
B. Unit not level
C. Poor ice quality due to water quality or icemaker problems.
D. Improper use of flaked ice.
Page 11