Filter
Top Products
Initial Start Up IOD150, IOD200, IOD250
1. Sanitize the ice storage system as instructed on Page 10.
2. Fill the hopper with sanitary ice.
3. Plug the unit’s power cord into an electrical outlet and the lighted sign should come on.
4. Dispense several containers of ice.
Note: In normal operation, pushing the ice
dispenser mechanism will cause ice to flow
from the ice chute. Ice flow will continue until
the dispenser mechanism is released or until
the hopper runs out of ice.
CAUTION: Use caution to avoid spilling ice
when filling dispenser. Clean up immediately
any spilled ice from filling or operating the unit.
To prevent contamination of ice, the lid must be
installed on the unit at all times.
Note: This unit is provided with a timer that will activate the ice dispenser rotor for 4 seconds
each time the unit is plugged into an electrical outlet and every hour (1) thereafter.
The agitation cycle helps to keep the ice from fusing together during long periods of non-use.
No ice is dispensed during the agitation.
Ice Machine Installation
Make sure the counter the dispenser is place on is structurally able to hold the combined weight of the
dispenser, ice and ice machine.
Remove the dispenser cover. (Retain for future use)
Place the appropriate stainless steel KBT adapter onto the top of the dispenser.
22 inch wide ice machine on a 22-inch wide dispenser. Part number KBT15022
22 inch wide ice machine on a 30-inch wide dispenser. Part Number KBT25022
30 inch wide ice machine on a 30-inch wide dispenser. Part Number KBT25030
Install the thermostatic bin control kit when applicable
Note: The thermostatic bin control kit is required on all ICE
Series Cubers.
Install the ice machine onto the dispenser, center the machine left to right and align the machine flush
to the back.
Install the thermostatic bin control cap tube into the thermal well mounted in the bin.
Note: The thermostatic bin control kit is required on all ICE
Series Cubers.
Fasten together at the back of the machine using fasteners from the icemaker and mounting hardware
from the kit.
Place the front cover plate onto the dispenser in front of the ice machine.
Follow the ice machine start-up instructions included with the ice machine.
Completion
Make a final check for any leaks and correct as necessary.
Reinstall the splash panel and secure it with two Phillips head screws.
Check for proper operation of the dispense system.
Instruct the site manager regarding the requirements for maintaining, operation and sanitizing the
dispenser.
Page 7