Filter
Top Products
For The Installer IOD150, IOD200, IOD250
Equipment Description
The IOD150, IOD200 and IOD250 are counter top mounted ice only dispensers. These units are
designed to dispense cube ice only and have ice storage capacities of 150 lb.,220 lb. and 250 lb.
respectively.
Site Preparation
The site chosen for the dispenser must be capable of supporting the dispenser with a full bin of ice
plus all other loads being placed on the surface supporting the dispenser. If an ice machine is being
placed on the dispenser, the weight of the ice machine must be included in the calculations to
determine the support structure needed for the dispenser.
Allow sufficient clearance above the unit for removal of the cover and for pouring ice into the bin.
A 115 volt, 15 amp electric outlet needs to be located within 6 feet of the unit. The outlet must be
properly grounded and fused. No other electrical appliance should be on the circuit. ALL
ELECTRICAL WIRING MUST CONFORM TO NATIONAL AND LOCAL CODES
Do not place the dispenser next to heat sources such as ovens, heat ducts or in the warm air
discharge from adjacent equipment.
The unit must be located near a building drain. Drain lines must be properly vented and pitched to
ensure free flowing of wastewater to the drain.
These dispensers are designed to dispense cubed ice only. Do not use flaked, crushed or
compressed ice forms.
If an Ice-O-Matic ice machine is to be placed on top of the dispenser, an adapter will be required.
Ice Machine Adapter 22 inch cuber Part Number KBT15022
Ice Machine Adapter 22 inch cuber on 30 wide dispenser Part Number KBT25022
Ice Machine Adapter 30 inch cuber Part Number KBT25030
This ice dispenser has been specifically designed to provide protection against personal injury and
eliminates contamination of ice. To ensure continued protection and sanitation, observe the following:
·ALWAYS: disconnect power to the dispenser before servicing or cleaning.
·NEVER: place hands inside of hopper or grate area without disconnecting power to the dispenser.
·Agitator rotation occurs automatically when dispenser is energized.
·ALWAYS: be sure the removable lid is properly installed to prevent unauthorized access to the
hopper interior and possible contamination of the ice.
·ALWAYS: be sure the upper and lower front panels are securely fastened.
·ALWAYS: keep area around the dispenser clean of ice cubes.
·CAUTION: Dispenser cannot be used with crushed or flaked ice.
Use of bagged ice, which has frozen into chunks, can void warranty.
The dispenser agitator is not designed to be an ice crusher. Use of large chunks of ice which “jam
up” inside the hopper will cause failure of the agitator motor and damage to the hopper. If bagged ice
is used, it must be carefully and completely broken into small, cubed size pieces before filling into the
dispense hopper.
Page 3