Cornelius 000 PLUS Refrigerator User Manual


 
14300614000
DAILY PRE-OPERATION CHECK
4. Make sure CO
2
cylinder regulator assembly 1800-psi gage indicator is not in shaded (‘‘change CO
2
cylinder’’) portion of dial. If so, CO
2
cylinder is almost empty and must be replaced.
5. Sufficient syrup supply in all soft drink tanks. If not, replenish syrup supply as instructed.
ADJUSTMENTS
ADJUSTING CO
2
REGULATORS
CO
2
regulators should be periodically checked for proper pressure settings and if necessary, adjusted as
instructed.
ADJUSTING DISPENSING VALVES WATER FLOW RATE
If adjustment of dispensing valves water flow rate should be necessary, adjust as instructed in Dispensing
Station Installation Instructions.
ADJUSTING WATER-TO-SYRUP ‘ ‘RATIO’ ’ OF DISPENSED PRODUCT
Water-To-Syrup ‘‘Ratio’’ of dispensed product should be checked and if necessary, adjusted as instructed in
Dispensing Station Installation Instructions.
ADJUSTING SIZE OF DRINK DISPENSED
Adjust drink size of dispensed product as instructed in Dispensing Station Installation Instructions.
REPLENISHING CO
2
SUPPLY
WARNING: CO
2
displaces oxygen. Strict attention must be observed in the prevention of
CO
2
(carbon dioxide) gas leaks in the entire CO
2
and soft drink system. If a CO
2
gas leak is
suspected, particularly in a small area, immediately ventilate the contaminated area before
attempting to repair the leak. Personnel exposed to high concentration of CO
2
gas will experience
tremors which are followed rapidly by loss of consciousness and suffocation.
NOTE: When indicator on CO
2
cylinder regulator assembly 1800-psi gage is in shaded (’ ’change CO
2
cylinder’’) portion of the dial, CO
2
cylinder is almost empty and should be changed. CO
2
supply should
be checked daily and if necessary, replenished as instructed.
REPLENISHING SYRUP SUPPLY
Syrup supply should be checked daily and if necessary, replenished as instructed.
CLEANING AND SANITIZING
DAILY CLEANING
Perform daily cleaning of dispensing station as instructed in dispensing station installation instructions. Outside
of Cooling Unit must be cleaned periodically.