Filter
Top Products
5 91875
OPERATING INSTRUCTIONS
Fill the hopper with ice and replace the lid. Pushing the dispenser lever will cause ice to flow from the ice chute.
Ice flow will continue until the lever is released. If ice does not dispense see the TROUBLESHOOTING GUIDE
to find the cause.
NOTE: Use caution to avoid spilling ice when filling dispenser. Immediately clean up any ice spilled
from filling or operating the unit. To prevent contamination of ice, the lid must be installed on the unit
at all times.
MAINTENANCE
The following dispenser maintenance should be performed at the intervals indicated:
DAILY (or as required)
Remove foreign material from the vending area sink to prevent drain blockage.
WEEKLY (or as required)
Clean vending area. Check for proper water drainage from the vending area sink.
MONTHLY
Clean and sanitize the hopper interior (see CLEANING INSTRUCTIONS).
If the dispenser fails to dispense ice when operated, check that the hopper has ice in it and that power
is being supplied to the unit. If the problem persists, refer to troubleshooting guide (page 7).
CLEANING INSTRUCTIONS
WARNING: DISCONNECT POWER BEFORE CLEANING! Do not use metal scrapers, sharp
objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage
may result. Do not use solvents or other cleaning agents, as they may attack the plastic
material.
DISPENSER
1. Clean the ice storage hopper at least once a month.
2. Remove the center screw on the agitator disk and lift off the agitator and the agitator disk assembly. Wash
and rinse them thoroughly.
3. Wash down the inside of the hopper and top cover with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.
4. Replace the agitator.