Filter
Top Products
691875
5. Sanitize the inside of the hopper and agitator with a solution of 1/2 ounce of household bleach in 1 gallon of
water. (200 PPM)
6. Replace the agitator disk. Sanitize as described in Step 5. Be sure the center screw is replaced and the
screw is tight.
7. Remove Ice Chute cover as follows:
A. Flex sides outward to disengage lower pins.
B. Lift Ice Chute cover to disengage upper pins.
C. Lower Ice Chute cover down out of unit. Note: it may be helpful to twist cover slightly.
8. Clean the inside of the ice chute and ice chute cover with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.
9. Reverse steps above to reassemble ice chute.
10. Sanitize as described in Step 5.