Filter
Top Products
6
Sanitizing Prior to Initial Use
The beverage system must be cleaned and
sanitized after installation is completed to safe
guard against any possible contaminants which
may have entered the system during transport or
installation. Refer to the “Cleaning & Sanitizing
the System” section of this manual for
procedures.
Apply Sealant to Base & Countertop
If the optional legs are not used to raise the
dispenser off the counter, the entire perimeter of
the base must be sealed at the counter top with
silicone (or other food grade approved sealant)
in order to comply with N.S.F. standards. Refer
to the template supplied in the Installation Kit.
Programming Portion
Control (optional)
a. Simultaneously, press and hold “S” (small)
and “XL” (extra large) push button switches
on the Coded Autoset Portion Control
Module until the LED light in the lower
right hand corner of the module starts
blinking. Release the switches. The blinking
LED indicates the programming mode is
active.
b. Place the cup under the white mixing valve
nozzle and push the selected size button
(small, medium, large, or extra large). Hold
the button in until the cup fills to the desired
portion, then release the button. Repeat the
above procedure for the remaining sizes.
c. After programming all the drink sizes, press
and release the “cancel/pour” ▲▼ switch to
return the Coded Autoset Portion Control to
the operational mode. The blinking LED
light will go out.
d. If at a future date, it is decided to change the
portion size of the drinks, the individual
sizes can be adjusted by the above
procedure. It is not necessary to reprogram
every size.
NOTE: The portion control has a full memory
retention in case of a power failure.
▲▼
S
L
M
XL
SMALL
LARGE
L.E.D.
MEDIUM
EXTRA-LARGE
CANCEL/POUR
CANCEL/POUR ▲▼:
a. Push and release cancel/pour button to stop
the valve from dispensing.
b. Push and hold for a continuous pour.
Brixing Concentrate
The following procedures describe how to adjust
the water to concentrate ratio (brix) according to
taste. Contact your concentrate supplier for
recommended brix ratios.
a. Remove the flavor strip cover above the
dispense valves.
b. Sample the finished drink. Increase or
decrease the water ratio by turning the water
flow control screw clockwise (more water)
or counterclockwise (less water) until the
desired water to concentrate ratio is
achieved. Repeat procedure on remaining
valves.
c. Replace the flavor strip cover.
NOTE: If the flow control does not respond
there may be debris caught between the internal
ceramic spool and sleeve. Try dislodging the
debris by pressing the dispense switch several
times or turning the flow control adjustment
screw all the way in and out several times.