Filter
Top Products
4
The Conserver 24LT dishmachine is not supplied with integral chemical dispensing feeder pumps. Instead, an independent chemical
dispensing system must
be connected to the unit prior to use in order to achieve required cleanliness and sanitation. Please consult
the literature that accompanied your independent chemical dispensing system for information concerning installation and operation of
the dispenser.
The Conserver 24LT requires that a separate chemical feeder be connected to it to provide the required sanitizer. This
feeder needs to be able to provide 2.271 ml of a 10% Chlorine sanitizer for every machine cycle.
Chemical feeder dispensing tubes are fed into the Conserver 24LT through the white bulkhead fitting in the back lower por-
tion of the unit.
WARNING: CHLORINE-BASED SANITIZERS CAN BE DETRIMENTAL TO YOUR MACHINE IF THE CHEMICAL SOLUTION
IS TOO STRONG. SEE YOUR CHEMICAL PROFESSIONAL TO ENSURE YOUR DISPENSER IS SET UP CORRECTLY.
TO PREPARE PUMPS FOR OPERATION
The Conserver 24LTP dishmachine is supplied with detergent, rinse additive and sanitizer dispensing feeder pumps. Locate the open
ends of the chemical tubes with the tube stiffeners and place each one in the appropriate container.
A. Red Tubing = Detergent
B. Blue Tubing = Rinse Aid
C. White Tubing = Sanitizer
PRIMING CHEMICAL FEEDER PUMPS
Chemical feeder pumps need priming when the machine is first installed or if for some reason the chemical lines have been removed
and air is allowed to enter.
CAUTION: Water must be in the sump and wash tank prior to the dispensing of chemicals. Sanitizer in concentration
is caustic and may cause damage without dilution.
1. Verify that the proper chemical tube stiffener inlet is in the proper container.
2. Use the toggle switches on the right side of control box to prime each pump. There are two (2) switches mounted by the chemical
feeder pumps. One will prime the sanitizer pump only, and the second will prime either the detergent or rinse aid pump, depending upon
which way it is depressed.
3. To prime the pumps, hold the switch in the momentary position until chemical can be observed entering the sump.
4. Detergent is dispensed as required during the wash cycle by the cam timer. The amount of detergent may need to be increased or
decreased depending on water quality and type of detergent. It is adjusted by changing Cam 7 on the cam timer. See the Conserver
24LTP cam timer operation instructions.
5. Rinse additive is dispensed as required into the final rinse. The amount of rinse aid may need to be adjusted depending on water
hardness and results. It can be changed by changing Cam 6 on the cam timer. See the Conserver 24LTP cam timer operation instruc
-
tions.
6. Sanitizer (either chlorine or iodine) is dispensed into the final rinse. The amount of sanitizer may need to be adjusted depending on
the concentration and type of sanitizer used. It is adjusted by changing Cam 8 on the cam timer. See the Conserver 24LTP cam timer
operation instructions.
WARNING: Some of the chemicals used in dishwashing may cause chemical burns if they come on contact with your
skin. Wear appropriate protective gear when handling these chemicals. If you do come in contact with these chemicals
flush the area with fresh water.
CHEMICAL DISPENSING EQUIPMENT