Filter
Top Products
]]Oven Operation
• • • • • • • • • • • • • • • • • • • • 41. • • • • • • • • • • • • • • • • • •
Probe
To assure excellent results every time when roasting, use the
probe supplied with your wall oven. " °
• _The probe must be removed from the oven when it is
Installing and Setting the Probe be usea.
• Because of the excellent insulation of the oven, the
1. Insert the probe into the food item. (For meats, the probe retained heat Continues to :cook the 'food after the
tipshould belocated in thecenter of the thickest part of the signal has sounded and the oven has cycled off. For
meat and not into the fat or touching a bone.)
this reason it is important to [emove the food from the
2. Insert the probe plug into the receptacle located on the top Oven as soon as the signal sounds,
left of the oven. Be certain to insert plug into the recep- • Use thehandle of the probe for inserting orremoving.
tacle all the way. Do not pull on the cable. Use a pot,holder to remove
• After the probe is in- since probe becomes hot.
serted, the indicator
word PROBE will flash • For frozen meats, insert probe after 1-2 hours of
and a beep will sound roasting.
reminding you to enter
the desired probe temp- • To clean cooled probe, wipe with a soapy dishcloth.
erature. Do not submerge probe in water.
3. Press Probe pad. The display will show three dashes.
4. Press the appropriate number pads to set the internal
temperature desired. (Allowable range is 100° to 200°F.)
• After five seconds the display will show probe
temperature or 95°,whichever is higher. Indicator
words CONV, BAKE, ROAST will flash.
5. PressBake or Convect Roast pad. The display will show
three dashes.
6. Press the appropriate number pads for desired oven tem-
perature.
7. When the selected internal temperature of the food has
been reached, the oven will shut offand a chime will sound
four times. Plus, the actual probe temperature will flash
and the word "End" will be shown in the display.
A chime will sound every minute for 10 minutes or until
the Cancel pad is pressed.
• If the probe is not removed, a beep will sound
continuously until the probe is removed. (Hold
probe plug with a potholder when removing from
the oven.)