Filter
Top Products
Before You Call for Service
If the cooling fan continues to operate after the oven has
been turned off: If You Need Service:
• This is normal and the fan will automatically shut off when • Call the dealer fromwhom yourappliance waspurchased
the oven is cooled, or call Maytag Appliances Sales Company, Jenn-Air
Customer Assistance at 1-800-688-1100 or 1-423-472-
3333 to locate an authorized servicer.
If a fan is heard while using the broil and clean modes:
• This is the cooling fan and is normal. The fan will con- • Be sure to retain proof of purchase to verify warranty
tinue to run after use until the oven cools, stares. Refer to WARRANTY (last page) for further
informationofowner'sresponsibilitiesforwarranty service.
If probe does not work: • ff the dealer or service company cannot resolve the
check to be sure probe plug is properly inserted into oven problem, write to Maytag Appliances Sales Company,
receptacle. Arm: CAIR® Center. P.O. Box 2370, Cleveland. TN
• probe may not be positioned in food properly. 37320-2370, or call 1-800-688-1100 or 1-423-472-3333.
• probe temperature may have been improperly set.
U.S. customers using TI'Y for deaf. hearing impaired or
speech impaired, call 1-800-688-2080.
If convection fan does not operate during drying:
• Check that the magnetic door spacer was correctly placed NOTE: When writing or calling about a service problem.
on the slightly recessed circular area on the upper center please include the following information:
of the oven door. (See pages 15 and 16.) a. Your name. address and telepohone number:
b. Model number and serial number:
Fault Codes c. Name and address of your dealer or servicer:
d. A clear description of the problem you are having;
• Fault codes are shown in the display as "F" and a number, e. Proof of ourchase (sales receipt).
If a fault code appears in the display and beeps sound,
press the Cancel pad. If the fault code and beeps continue • User's guides,service manuals, and parts information are
after pressing Cancel, disconnect power to the oven. Wait available fromMaytag Appliances Sales Company, Jenn-
a few minutes, then reconnect power to the oven. If the Air Customer Assistance.
fault code and beeps still continue, disconnect power to
the wall oven and call an authorized servicer. All specifications subject to change by manufacturer
• If the oven is heavily soiled, excessive flare-ups may re- without notice.
sult in a fault code during a clean cycle. Press Cancel pad
and allow the oven to cool for one hour, then reset the
clean cycle. If the fault code and beeps still continue, dis-
connect power to the appliance and call an authorized
servicer.
• If an error beep sounds (two short beeps) with no fault
code in the display, clean any spill from key pad area within
30 seconds. If, after 30 seconds the spill is not removed or
another problem exists, an F7 fault code will be displayed.
Disconnect power to the appliance and call an authorized
servicer.