Jenn-Air Dual Fuel Cooktop Range User Manual


  Open as PDF
of 6
 
Installation of LP Orifice Spuds
With a quarter, engage slot and rotate cap 1/8 of a tL
counterclockwise. To remove cap, turn cap over and reinst_
= ° 00
_ . (_
NaturalSetting LP Setting
L Figure8: Conversionof Harper-Wyman
P"" 0 AppliancePressureRegulator
// "_ _ _ After conversion, steps A and B have been completed, che¢
ART#9215-033-0 the appearance of each burners' flame at the Hi and L
settings against figure 9. If the flames appear too large or to
small, review all steps to make sure they were complete
correctly.
Figure6 ,.P"-"_gs' ', __
B. Invert Cap in Appliance Pressure Regulator ,/ I_1o
(See figures 7 and 8.) With the appliance installed, the 2.,,._ I; - _
regulator is located on the underside of the burner box on the
right hand side at the inlet to the gas manifold. Identify the
make of appliance regulator on the unit and follow the
5 6 7 8
R._ LP RER.ACEPININC,AP.
CONVERTE APPLYSIDEWARD
CAP I ,_ FINGERPRESSURE Figure9: FlameAppearanceat Hi and Lo
_'--_A NDPIN J _ TO_ PIN
NAT_jl r _ _ I '±
Figure 7:Conversionof Maxitrol
AppliancePressure Regulator
 previous