Filter
Top Products
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker
panel Be sure that the entire oven cavity including the lightbulb iscool before attempting
to remove.
TO replace light bulb:
1. Carefully unscrew the glass light lens.
2. To obtain firm grasp on bulb, wear protective rubber gloves.
Remove by turning bulb to the left. Do not tough a hot oven _[
light bulb with a dampcloth as bulb will break. Note: If the
bulb does break andyou wish to remove it,be certain power
supply is disconnected and wear protective gloves. You
may contact your authorized Jenn-Air Service Contractor for
service.
3. Replace bulb with a 40 watt oven-rated appliance bulb. Bulb with brass base is
recommended to prevent fusing of bulb into socket.
4. Replace bulb cover and reconnect power to oven. Reset clock.
Before replacing light bulb, DISCONNECT POWER TO RANGE.
To replace fluorescent surface light: Grasp the top of backguard with thumbs under
front edge and gently pull outward while lifting to release trim from catches at each end.
Remove bulb and replace with an 18 watt fluorescent tube. Snap top tdm back into
place, restore power and reset clock.
TOPTRIMOF
BACKGUARD FLUORESCENTTUBE
36