Filter
Top Products
To check STOP TIME: Hold in STOP TIME button until the words STOP TIME
appear in the DisplayWindow. The stop time will be displayed briefly, then Displaywill
return to on-going program.
To change STOP TIME before cleaning begins:
1. Holdin STOP TIME button until words STOP TIME appear in the Display Window.
2. Turn SET dial to desired STOP TIME.
3. Push ENTER button to enter new stop time.
NOTE: If more than 7 seconds elapse between holding in START TIME button or
STOP TIME button and turning the SET dial,the display window will automatically
return to on-going program.
NOTE: If more than I minute elapses between turning SET dial to a new time and
entering new START TIME andSTOP TIME, the entire program will be cancelled
and display will return to time of day clock.
To stop cleaning process before lock indicator light comes on:
1. Move the DOOR LOCK LEVER to the left.
2. Turn SELECTOR and TEMPERATURE knobs from CLEAN to OFF.
3. Push CANCEL button twice.
To stop cleaning process after lock indicator light comes on:
1. Push CANCEL button twice.
2. Leave the TEMPERATURE and SELECTOR knobs in the CLEAN position.
3. Allow oven to cool until the LOCK INDICATOR LIGHT goesout. This may take up
to 45 minutes, depending on how long the oven has been on.
4. After LOCK INDICATOR LIGHT goes off, movethe DOOR LOCK LEVERto the left.
5. Turn SELECTOR and TEMPERATURE knobs from CLEAN to OFF.
NOTE: When SELECTOR knob isturned to CLEAN, a fan comes on. If this fan
is not operating, the oven will go through the self-cleaning process at a reduced
oventemperature andtheoven will not cleaneffectively. Ifthefan doesnot operate,
contact your Jenn-Air Authorized Service Contractor for service.
35