Filter
Top Products
22
Complete Installation
1. Insert downdraft vent filter and place vent cover over
opening.
2. Reconnect power.
3. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
4. Check that you have all of your tools.
5. Dispose of/recycle all packaging materials.
6. Check that the range is level. See “Level Range.”
7. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth. For more information, read
the “Range Care” section of the Use and Care Guide.
8. Read “Range Use” in the range Use and Care Guide.
9. Turn on surface burners and oven. See the Use and Care
Guide for specific instruction on range operation.
If range does not operate, check the following:
■ Household fuse is intact and tight; or circuit breaker has not
tripped.
■ Range is plugged into a grounded outlet.
■ Electrical supply is connected.
■ See “Troubleshooting” in the Use and Care Guide.
When the range has been on for 5 minutes, check for heat. If
range is cold, turn off the range and contact a qualified
technician.
10. Use the Flow Tester Card provided with your range to check
the air flow (see card for step by step instructions).
If there is not sufficient air flow, review the “Venting
Requirements” and “Venting Methods” sections.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use
and Care Guide or contact the dealer from whom you purchased
your range.
Moving the Range
When moving range, slide range onto cardboard or hardboard to
avoid damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
For power supply cord-connected ranges:
1. Disconnect range from downdraft vent system.
2. Slide range forward.
3. Unplug the power supply cord.
4. Complete cleaning or maintenance.
5. Plug power supply cord into a grounded outlet.
6. To check that anti-tip bracket is installed, remove access
panel and use a flashlight to look underneath the bottom of
the range:
■ Look for the anti-tip bracket securely attached to floor or
wall.
■ Slide range back so rear range foot is under anti-tip
bracket.
7. Check that range is level.
8. Reconnect range to downdraft vent system.
A.Filter
B.Grate
A
B
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.