Filter
Top Products
13
Roll-Out Rack
The roll-out rack allows easy access to position and remove food in
the oven. It is not recommended to use the roll-out rack in the top
rack, position 7, or the bottom rack, position 1.
Open Position
Closed and Engaged Position
To Insert Roll-Out Rack
1. Angle the front of the rack assembly up, and then insert the
rack frame into the “V” cutout in the rack guides of the oven
cavity.
2. Keep rack assembly lifted up at an angle, and then push in to
bypass the lower “V” cutout.
3. Lower the front of the rack assembly, and then gently slide
rack assembly into oven, bypassing the “V” cutouts. Push the
rack assembly into the oven until it stops at the ladder in the
back of the oven.
4. Reach through the rack to hold the sliding rack and the front
crossbar. Lift the front of the rack assembly, and then push the
rack assembly to the back of the oven. Lower the front of the
rack assembly so the ladder hook engages with the ladder on
both sides of the oven.
To Remove Roll-Out Rack
1. Push the sliding rack in completely so that it is in the closed
and engaged position.
2. Reach through the rack to hold the sliding rack and the front
crossbar. Lift the front of the rack assembly to disengage the
ladder hook from the ladders at the rear of the oven, and then
pull the rack assembly forward.
3. Using 2 hands, gently pull the sliding rack and the rack frame
at the same time to the “V” cutout. Angle the rack so that the
front is higher than the back, and then gently pull rack past “V”
cutout and then out of the oven.
To avoid damage to the sliding rack, do not place more than 25 lbs
(11.4 kg) on the rack.
Do not clean the roll-out rack in a dishwasher. It may remove the
rack’s lubricant and affect its ability to slide.
See the “General Cleaning” section for more information.
A. Rack frame
B.Sliding rack
A.Rack frame
B.Sliding rack
A.“V” cutout
B.Rack guides
A
B
A
B
A
B
A.“V” cutout
B.Rack guides
C.Ladder hook
D.Ladder
A.Sliding rack
B.Front crossbar
A
B
C
D
A
B