Filter
Top Products
Number Pads
Use to set time or temperature.
Oven Light Pad (Control Panel)
The oven light automatically comes on whenever the oven door is opened. When door is closed, touch
the Oven Light Pad to turn oven light on or off. Note: A beep will sound every time the Oven Light
Pad is touched.
Display Window
, 1
Shows time of day, timer, and
oven functions.
Display Numbers:
cwlv BANE IlMn CONI WE ROAST
DELAY START COOK TIMED
CLEM Brlllll CLEAK BROIL
STOP TIMER KHZ
q
lllD~EN LOCK PBUUT fiJII LBCK PBEIIEAT m
0 Show time of day.
I I
0 Countdown of time remaining when using time functions.
0 Show temperature of oven as it rises to reach programmed temperature and the set tempera-
ture once it is reached.
0 Recall programmed temperature or time when commanded.
0 Rounding of Display Numbers: Temperature range is 100” to 550°F and can be set in 5”
increments. When setting temperature, the control will round it to the nearest 10”. For example,
if 237” is entered, the control will round the temperature to 240°.
Prompts:
0 Serve as a reminder to shut oven door, if it is open, for self-cleaning operation when the word,
door,
is displayed.
0 “Err” will appear in the Display when an impropertemperature or time has been entered. “Err”
will flash and a beep will be heard three times. Then, the Display will return to the previous
Display before the error was entered.
Indicator Words:
0 Flash to prompt next step.
0 Indicate status of programmed function.
0 Show programmed function when recalled.
0 Show oven selected. U - is the upper oven; L - is the lower oven. (Model WW30430)
Chimes vs. Beeps
0 A chime sound is used to designate the end of a timing or cooking operation.
0 A beep sound will be heard when any pad is touched. A series of short beeps are used to
designate an incorrect entry, door is open when set for a self-clean, probe needs to be removed
and a fault code.
End of Cycle Chimes:
0 The end of cycle chimes is four short chimes followed by “reminder” chimes for a specified
length of time, until you cancel that function. For the Timer function, there are two “reminder”
chimes every 30 seconds for five minutes.
For the Timed Cook, functions there is one
“reminder” chime every minuteforten minutes. To cancel these “reminder” chimes, touch the
appropriate pad again (either the
Timer
Pad or Cook Time Pad). You may also touch the
Cancel Off Pad to cancel the “reminder” chimes, but it will also cancel all other oven functions.
0 If you would like to eliminate all the “reminder” chimes entirely, touch and hold the Cancel Off
Pad for twelve seconds. (This will oat the initial four short chimes).
0 To return the “reminder” chimes, touch and hold the Cancel Off Pad for twelve seconds.
NOTE: To change the oven to a 24 hour clock or Celsius (C) degrees, contact your authorized
Jenn-Air Service Contractor or installer.
7