Filter
Top Products
5
Installation
Technical Data
Appliance dimensions
Worktop cut-out dimensions
Cooking rings
Electrical Connection
1 This hob must be earthed.
Electrical Requirements
Any permanent electrical installation must comply with the
latest I.E.E. Regulations and local Electricity Board regula-
tions. For your own safety this should be undertaken by a
qualified electrician, e.g. your local Electricity Board, or a
contractor who is on the roll of the National Inspection
Council for Electrical Installation Contracting (NICEIC).
Electrical Connection
The hob is designed to be connected to 230 V (50 Hz) elec-
tricity supply. Before connecting to the mains supply ensure
that the mains voltage corresponds to the voltage on the
rating plate underneath the hob.
For UK only
It is necessary that you install a double pole switch between
the hob and the electricity supply (mains), with a minimum
gap of 3 mm between the switch contacts and of a type suit-
able for the required load in compliance with the current
rules.
1 The switch must not break the yellow and
green earth cable at any point.
It is necessary that the yellow / green earth
wire is about 2 cm longer than the live and
neutral ones.
Important
After installation and connecting, the cable must be placed
so that it cannot at any point reach a temperature of more
than 60°C above the ambient temperature.
Before the hob is connected, check that the main fuse and
the domestic installation can support the load; and that the
power supply is properly earthed.
The manufacturer disclaims any responsibility should these
safety measures not be carried out.
Width 590 mm
Depth 520 mm
Height 47 mm
Width 560 mm
Depth 490 mm
Position Diameter Power
Front left 210mm 2300W
Rear left 145mm 1200W
Rear right 180mm 1800W
Front right 145mm 1200W
Connection voltage 230 V ~ 50Hz
Maximum connected load power 5,8kW