John Lewis JLBIDO911 Oven User Manual


 
With one hand, carefully lift the glass panel
to disengage it from the location points
under the handle.
With your other hand, hold the outer door
to ensure it does not spring shut on
removing the inner panel.
Close the oven door.
Warning! If the door glass panel
becomes chipped or has deep
scratches the glass will be weakened
and must be replaced to prevent the
possibility of the panel shattering.
Please contact your local service force
centre who will be pleased to advise
further.
To replace the inner door
glass
Holding the glass panel in your right hand fully
open the oven door with your left.
Gently ease and push the glass into the
location points under the handle before
lowering and sliding the glass into position
under the hinge location points at the rear.
Ensure the glass is properly located and the
text 'Top' is facing towards you and at the top
edge of the door.
Warning! Do not attempt to use the
oven without the glass being in place.
Replacing an oven light
bulb (main oven)
The type of bulb required is a 300°C 25 watt
small Edison Screw.
Warning! Disconnect the appliance
from the electricity supply before
replacing the bulb.
1. Make sure the appliance is cool before
replacing the bulb.
2. Open the oven door and remove the
shelves and wirework runners.
3. Pull the glass bulb cover towards you and
then pull it off. If necessary, use a
screwdriver to carefully lever off the
cover, taking care not to damage the oven
cavity.
4. Unscrew the bulb by turning it to the left.
5. Fit a new bulb and then replace the glass
bulb cover.
6. Refit the wirework runners and replace
the shelves.
7. Restore the electricity supply and reset
the time of day.
38