Filter
Top Products
16
Removing the ve ntila tio n grill
C lea ning
Clean the freezer at regular intervals. Don't use
detergents, abrasive powders, high perfumed cleaning
products, wax polishes or cleaning products containing
bleach or alcohol when cleaning the product
Disconnect the appliance from electricity supply.
Clean the inside and accessories with warm water and
bicarbonate of soda (5ml to 0,5 litre water) Rinse and
dry thoroughly.
Regularly check the door seals and wipe clean to ensure
they are clean and free from debris.
Wash the outer freezer with warm soapy water. Remove
the ventilation grill (see above) and vacuum-clean under
thecabinet.Onceortwiceayeardustthecondenser
(grill) and the compressor at the back of the appliance,
with a brush or vacuum cleaner, as an accumulation of
dust will affect the performance of the appliance and
cause excessive electricity consumption.
When moving the freezer, lift it by the front edge
to avoid scratching the floor.
Defrosting
Defrosting is not necessary.
Every 24 hours, the evaporator is defrosted
automatically.
To change the light bulb
This freezer is fitted with a clear halogen light bulb. The
light is switched on automatically when the door is
opened. If the bulb fails and needs to be replaced;
disconnect the power from the freezer.
Cut the packaging containing the new bulb.
Keep the packaging on to hold the bulb when setting it
into the socket. Do not touch the bulb with your bare
fingers. Halogen light bulbs are sensitive to grease from
the skin.
When the appliance is not in
use
Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the doors
ajar to prevent unpleasant smells.
If the freezer is to be left on, ask somebody to check it
regularly to prevent the food inside from spoiling in case
of a power failure.
UV-blocked
Low pressure20W/12V
G4
Maintenance and Cleaning
You must disconnect the a ppliance f rom t he electr icity
supply, bef ore ca r r ying out a ny cleaning or ma intenance
wo r k .
The ventila tion g r ill ca n b e removed, e .g . t o wa sh t he
g r ill.
M a ke sure the door is open when removing the
ventilation gr ill. U nsnap the upper edg e of t he gr ill by
pulling outwa rd/ downwa rd. Then pull t he g r ill str a ig ht
out t o completely remove it.