Filter
Top Products
with its tapered end down into the water container (Fig. 10).
Make sure it fits inside the fins and push down gently.
• Close the cartridge holder making sure it snaps into place
(Fig. 11). Fill the water tank with fresh cold water and replace.
Activating:
You must activate the cartridge for the machine to monitor it
properly. Otherwise the C9 OT assumes decalcifying mode.
READY.
1. Push the Rotary Dial until display shows RINSE.
2. Turn the Rotary Dial until the display shows FILTER – and
push the Rotary Dial to enter the program
NO –.
3. Turn the Rotary Dial until
YES ✓is displayed and push the
Rotary Dial.
OK is displayed briefly and then INSERT and the
Rinse button illuminates.
4. Place a 20 oz. container under the steam nozzle (Fig. 18).
5. Push the Rinse button
FILTER RINSING. For the next 60
seconds the machine will push water through the cartridge
and out through the frothXpress system. Initially, the water
may have a slight discoloration. The program will stop auto-
matically. The display shows
HEATING, then READY.
Please note: You can stop the water flow at any time by push-
ing Rinse button. Empty the container, replace and push the
Rinse button to complete the activation process.
Please note: As long as the filter is activated, the water
hardness setting is automatically turned off.
13b. AUTOMATIC CLEARYL REPLACEMENT
The filter is monitored automatically. After approx. 75 liters of
water (~2,500 oz.) the display shows
READY / FILTER. The
Rinse Button will light up.
Important: Once the filter has lost its calcium suppressing
abilities, calcium will build up inside the machine. Since the
Water Hardness Selector is off, the machine will not remind you
when to decalcify. If the filter is not replaced, the calcium
buildup will clog and damage your machine.
1. Push Rinse Button
CHANGE.
2. Remove the water tank and the old filter.
3. Make sure the water tank is empty.
4. Remove the new cartridge from its bag, rinse under running
water and insert in water tank. Fill the water tank with water
and replace. Now install as explained in chapter 13a,
steps 4 and 5.
13c. MANUAL CLEARYL REPLACEMENT
If the filter is more than 2 months old and the display does not
indicate to replace filter, replace as follows.
READY.
• Push the Rotary Dial until the display shows RINSE.
• Push Rotary Dial again, display shows
C CLEANING.
• Turn the Rotary Dial until the display shows FILTER.
• Push the Rotary Dial CHANGE.
• Now install as explained in chapter 13a, steps 4 through 6.
13d. DO NOT LET THE CLEARYL FILTER DRY OUT!
If the filter is not immersed in water, the granular center will dry
out and block any water from passing through.
• If machine is not used for a few days, leave some water in the
water tank so the filter will not dry out. Upon using the
machine again, fill the water tank with fresh water and process
approx. 2 oz. of water through the hot water spout.
21.