Filter
Top Products
cases no further coffee brewing is possible before the task has
been completed.
PRESS RINSE
Push the Rinse button (Fig. 3.2). The machine pumps hot water
through the coffee spouts or fills the system initially (chapter 6c)
or continues a cleaning program.
FILL WATER TANK
The water tank is almost empty. Add water before resuming
brewing coffee.
EMPTY GROUNDS or EMPTY TRAY
When this message appears, you must empty the used coffee
grounds from the used coffee container and the water from the
drawer. Make sure the Dual Coffee Spouts are moved upwards.
• Carefully remove the drawer (Fig. 20, 21, 22).
TRAY MISSING.
• Empty the drawer and the used coffee container, assemble and
replace READY.
Please note: If the machine is not used for a few days, pull out
the tray and empty the used coffee container. Used, moist coffee
grounds can develop mold and mildew.
Important: If you pull out the drawer without any corresponding
message in the display you must empty the used coffee container.
The machine assumes that it will be emptied. If you do not
empty the container, used coffee overflows inside the machine
and causes serious damage to the coffee release mechanism.
Please note: The machine does not sense if the used coffee
container (Fig. 2.19) is inserted. If the used coffee container is
not inserted, ground coffee discharges into the drawer.
TRAY MISSING
Insert the drawer with the empty used coffee container.
FILL BEANS: Add beans to the bean container.
READY / CLEAN
After approx. 200 coffee brewings or 80 initial rinsing cycles you
must run a tablet cleaning cycle. You can still make coffee, how-
ever we highly recommend to perform the cleaning cycle within
the next few days (chapter 16.1).
READY / DE-SCALE
It is time to decalcify the machine. You can still make coffee,
however we highly recommend to perform the decalcifying cycle
within the next few days (chapter 17.1).
Please note: If you use the Clearyl cartridge and the message
appears, then your cartridge function was not activated. Follow
the instruction in chapter 13a to program and activate the
cartridge. If the cartridge is already in use for several weeks
install a new cartridge.
READY / FILTER
It is time to replace the Clearyl filter (chapter 13b).
NOT ENOUGH PRE-GROUND
Not enough pre-ground coffee was filled into the ground coffee
funnel (Fig. 1.7). The C9 OT stops the operation (chapter 9d).
15.1 MANUAL RINSE CYCLES
The C9 OT will display when it’s time to perform certain cleaning
programs. You can also manually access these programs and
perform them.
READY.
• Push the Rotary Dial until the display shows
RINSE.
• Push the Dial again, C-CLEANING (for cappuccino cleaning)
• Turning the dial shows which maintenance programs can be
accessed:
C-CLEANING (chapter 15.2)
FILTER (chapter 13c); manual Clearyl filter replacement
25.