Filter
Top Products
21
2 Preparation
T Place a cup under the dual spout.
T Press and hold the
‘Coffee’ button.
‘Coffee’ and the fill volume are displayed.
T Hold the
‘Coffee’ button down until ‘Enough coffee? Press
button.’
appears.
T Release the
‘Coffee’ button.
Preparation starts and the coffee flows into the cup.
T Press any button as soon as there is sufficient coffee in the
cup.
Preparation stops.
‘Saved’ appears briefly on the display. The
set amount of water for one coffee is permanently stored.
‘Please select product:’ appears on the display.
E You can alter this setting at any time by repeating the above
procedure.
E The amount can be permanently adjusted to the cup size for
the products shown in the product selector too. To do this,
press and hold the Rotary Switch k until
‘Enough coffee?
Press button.’
appears.
E You can also permanently set the amount for all speciality
coffees, milk and hot water in programming mode (see Chap-
ter 4 ‘Permanent settings in programming mode – Product
settings’).
You have the option of configuring the start screen such that the
grinder selection (‘beans à la carte’) is always displayed. Before each
preparation, you can select which grinder is to be used and therefore
which coffee beans are to be used.
E If the grinder selection is activated, you can no longer set the
grinder for the individual products in programming mode (in
the
‘Product settings (2/5)’ programme item).
Example:Proceed as follows to activate ‘beans à la carte’ mode.
Precondition:
‘Please select product:’ is displayed.
O T Press the P button.
‘Maintenance status (1/5)’
g T Turn the Rotary Switch until the programme item ‘Machine
settings (4/5)’
is displayed.
Activating the grinder
selection