Filter
Top Products
- HOW YOUR REVERSE OSMOSIS SYSTEM WORKS -
REVERSE OSMOSIS WATER FLOW SCHEMATIC
PRODUCT
WATER
FAUCET
air gap __f _1=
gravity 4.
drain
BLUE _ PRODUCT WATER
RED-o
drain flow
control
check
SHUTOFF valve
WATER GREEN
! IN "" t_q
RO
PREFILTER MEMBRANE POSTFILTER
Figure 9
- CARE OF YOUR REVERSE OSMOSIS SYSTEM -
To keep your reverse osmosis system operating and
producing high quality water, you must make sure
supply water is always within the limits shown in the
specifications. Good supply water (soft water is rec-
ommended) helps to assure longer life from the RO
membrane cartridge, prefilter and postfilter car-
tridges. However, each of these will wear out in time
and need replacement.
This reverse osmosis system contains a replace-
able treatment component critical for effective
removal of total dissolved solids. The monitor
faucet feature provides continuous analysis of the
systems performance.
If the RO assembly is wall mounted, you may be able
to replace parts with the assembly left on the wall. If
not, simply lift the RO assembly from the mounting
washers and lay on the cabinet floor when replacing
the prefilter and post filter cartridges and RO mem-
brane.
Note: To prevent spillage, place a container under the
RO assembly, or put the RO assembly in a container
to catch the water.
CAUTION: Before disconnecting parts, be sure to
close the water supply valve to the RO.
11
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line