Filter
Top Products
Setting Oven Controls
Setting the Clock
The _ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash (See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press (_. "CLO" will appear in the display (Figure 2).
2. Press (_ (_ (_ pads to set the time of day to 1:30
(Figure 3). "CLO" will stay in the display. Press "CLO"
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold _'_ for 7 seconds. "CLO" will appear in the
display. "12h" (Figure 5) or "24h" (Figure 6) appears in the
display and the control beeps once.
2. Press _ to switch between the 12 and 24 hour time of clay
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3. Press to accept the change or press _ to reject the
change.
4. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
PRESS
O
QQdb
0
for 7 seconds
Q
O
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
!!C
17