Filter
Top Products
Before Setting Surface Controls
Assembly of the Surface Burner Heads, Burner Caps and Burner Grates for Regular Burners
It isvery important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates
are installed correctly and at the correct locations.
1. Remove all packing tape from cooktop area. Remove all
Burner Caps and Burner Heads.
2. Discard all packing material located under Burner Heads (if
applicable).
3. To replace the Burner Heads & Caps, match the letters
located under center of Burner Caps with the letters located
inside Burner Heads (Figure 1).
4. Match Burner Skirts with Burner Heads and Burner Caps
(see Figure 1). Replace the Burner Heads and Caps on
cooktop (see Figure 2). Carefully align the Electrodes into
slot or hole of each Burner Head (Figure 3). Note: The
Burner Heads should sit flat on Cooktop Burner Skirts.
5. Place the removable oven vent cover over the fixed oven
vent cover.
6. Unpack Burner Grates and position on the cooktop.
REMEMBER = DO NOT ALLOW SPILLS, FOOD, CLEANING
Figure 1
Figure 2
Figure 3 align into slot or hole for each
Burner Head
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner
Caps and Burner Heads in place whenever the surface burners are in use.
Dual Burner Head Assembly (some models only)
Make sure that the Burner Head, Burner Caps and Burner Skirt are
installed properly and at the correct locations.
1. Follow the Installation Instructions before installing and using your
new range.
2. Remove all packing tape from cooktop and the dual burner.
3. Discard all packing material located under all Burners (if applicable).
4.To install Burner Head, Caps & Skirt, refer to figure 1 and follow the
following steps:
Step 1: Align Burner Head Pin A on Burner Base Hole.
Step 2: Place Burner Skirt around Head and Base.
Step 3: Align the Burner Outer Cap Hole into Burner Head Pin B.
Step 4: Place Inner Burner Cap centered on Burner Base.
5. Put back the grates on the cooktop.
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
ORIFICE HOLDER OPENING. Always keep the Burner Caps and
Burner Heads in place whenever the surface burners are in use.
Burner Step 4
Inner Cap
Burner
Outer Cap
Burner Outer
Cap Hole
Burner
Skirt
\
',\
Burner Head
Pin B
Burner
Head
Burner
Base
Step 3
Step 2
//
/
/
Burner
Head
PinA
Step 1
Burner
Base
Hole
9
Figure 4