Filter
Top Products
Self Cleaning
INSTRUCTIONS
When the Self-Clean Cycle is Completed
1.
.
The "DOOR LOCKED", "CLEAN" and "HOT" icon wiil remain in
the display.
Once the oven has cooled down for approximately 1 HOUR, and
the "DOOR LOCKED" icon is no longer displayed, the oven door
can then be opened.
PRESS DISPLAY
Fig. 1
Stopping or interrupting a SeJf=Cleanlng Cycle
If it becomes necessary to stop or interrupt a self-cleaning cycle due
to excessive smoke or fire in the oven:
1. Press @.
2. Once the oven has cooled down for approximately 1 HOUR, and
the "DOOR LOCKED" icon is no longer displayed, the oven door
can then be opened (Fig. 1).
@
Adjusting Oven Temperature
The temperature in the oven has been pre-set at the factory. When first using the oven,
be sure to follow recipe times and temperatures. If you think the oven is cooking too hot
or too cool for the temperature you select, you can adjust the actual oven temperature
to be more or less than what is displayed. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The
baking results should help you to decide how much of an adjustment is needed.
Note: The oven temperature
adjustments made with this
feature will not change
the Self-Clean cycle
temperature.
INSTRUCTIONS
To adjust the oven temperature higher
1.
.
.
Press _ for 6 seconds. "UPO" and degree offset will appear in
the display (Fig. 2).
To increase the temperature use the number pads to enter the
desired change (Example 30°F) 30 (Fig. 3). The temperature may
be increased as much as 35°F (19°C).
Press s_ to accept the temperature change and the display will
return to the time of day (Fig. 4). Press _ to reject the change if
necessary.
To adjust the oven temperature lower
1. Press _ for 6 seconds. "UPO" and degree offset will appear in
the display (Fig. 2).
2. To decrease the temperature use the number pads to enter the
Flex
desired change (Example -30°F) 30 and then press Clean(Fig. 5).
The temperature may be decreased as much as 35°F (19°C).
3. Press _ to accept the temperature change and the display will
return to the time of day (Fig. 4). Press _ to reject the change if
necessary.
PRESS
3O
or
@
Q
FJex
3 0 cleo0
or
@
DISPLAY
Fig. 2
Fig. 3
Fig. 4
Fig. 5
29