Filter
Top Products
Setting the Oven Controls
Seffing Continuous Bake or 12 Hour Energy Saving
Flex
The Set/Off and Cba. pads control the Continuous Bake or 12 Hour Energy Saving features. The
oven control has a factory preset built-in 12 Hour Energy Saving feature that wiii shut off
the oven if the oven control is left on for more than 11 hours and 59 minutes. The oven can
be programmed to override this feature for Continuous Baking.
INSTRUCTIONS PRESS DISPLAY
To set the control far Continuous Bake or 12 Hour Energy
Saving features
Timer
1. Press and hold Set/Off for 7 seconds or until the control beeps once
(Fig. 1). "12Hr OFF" or "StAy On" wiii appear in the display and
the control wii[ beep once.
Flex
2. Press Cleanto switch between the 12 Hour Energy Saving and
continuous bake features. Note: "|2Hr OFF" (Fig. 2) in the
display indicates the control is set for the 12 Hour Energy Saving
mode and "StAy On" (Fig. 3) indicates the control is set for the
Continuous Bake feature.
3. Press _ to accept the change (Fig. 4; display will return to time
of day) or press _ to reject the change.
Timer
Set/Off for 7 seconds
Flex
Clean
Setting Timer
Timer
The TUMER Set/Off pad controls the Timer feature. The Timer serves as an extra timer in the
kitchen that will beep when the set time has run out. It does not start or stop cooking.
The Timer feature can be used during any of the other oven control functions. Refer to
"Minimum and Maximum Control Pad Settings" for time amount settings.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
INSTRUCTIONS PRESS DISPLAY
To set the Kitchen Timer (example for 5 minutes)
Timer
1. Press Set/Off (Fig. 5).
2. Press the number pads to set the desired time in the display
(example 5). Press _. The time wiii begin a count down (Fig. 6).
Note: If _ is not pressed the timer wiii return to the time of day
after 25 seconds.
3. When the set time has run ouh the clock wiii sound with 3 long
Timer
beeps every 5 seconds until Set/Off is pressed (Fig. 7).
To cancel the Timer before the set time has run out
T_mer
Press Set/Off. The display wiii return to the time of day.
Timer
Set/Off
Q Fig. 5
Timer
Set/Off Fig. 6
Timer
Set/Off
Fig. 7
To Set Add 1 Minute Feature
Add I Add 1
The Minutepad is used to set the Add 1 Minute feature. When the Minutepad is pressed, 1 minute is added to the Timer feature
Add 1
if this feature is already active. If the Timer feature is not active and the M_nutepad is pressed, the Timer feature will become
active and will begin counting down from 1 minute. For further information on how to set the Timer feature see Setting Timer
instructions above.