Filter
Top Products
Setting the Oven Controls
Setting the Clock
The 4(_ pad is used to set the dock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
time in the display will flash (See Fig. 1).
INSTRUCTIONS PRESS
Fig. 1
DISPLAY
To set the clock (example below for 1:30)
1. Press (_. "CLO" will appear in the display (Fig. 2).
2. Press ] 3 0 pads to set the time of day to 1:30 (Fig. 3). Press _(_.
"CLO" will disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day dlsplay
1. Press and hold 4_ for 7 seconds until "12Hr day" or "24Hr dAy
appears in the display.
Flex
2. Press Cleo,to switch between the 12 and 24 hour time of day
display. 12Hr dAy (Fig. 5) or 24Hr dAy (Fig. 6) will be displayed.
3. Press _ to accept the change or press _ to reject the change.
4. Reset the correct time as described in To set the (:lock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
®
130_
@ for 7 seconds
Flex
Clean
Setting Silent Control Operation
_, Delay , Flex
/he Startand Cleonpads control the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated without sounds or beeps whenever
necessary. If desired the control can be programmed for silent operation and later returned
to operating with aii the normal sounds and beeps.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
INSTRUCTIONS PRESS DISPLAY
To change control from normal sound operation to silent control
operation
1. To tell if your range is set for normal or silent operation press and
Delay
hold Startfor 7 seconds (Fig. 7).
Flex
2. Press Cleanto switch between normal sound operation and silent
operation mode. The display will show either bEEp On (Fig. 8) or
bEEp OFF (Fig. 9).
If bEEp On appears (Fig. 8), the control will operate with normal
sounds and beeps. If bEEp OFF appears (Fig. 9), the control is in
the silent operation mode.
3. Press _ to accept the change or press _ to reject the change.
Delay
Start for 7 seconds
Flex
Clean
Fig. 7
Fig. 8
Fig. 9