Filter
Top Products
43
OCCURRENCE POSSIBLE CAUSE/SOLUTION
Self-cleaning cycle does not
work
• Make sure the oven door is closed.
• Make sure you have removed the oven racks and the oven rack supports from
the oven.
• Controls not set properly. Follow instructions under “Dual Convection Lower
Oven Self-Cleaning Cycle”.
Flames inside oven or smoking
from oven vent
• Excessive spillovers in oven. For example this will happen for pie spillovers or
large amounts of grease left on the oven bottom. Wipe up excessive spillovers
before starting oven. If fl ames or excessive smoke are present see “Broil” in the
Lower Oven Operating Instructions section.
Lower Oven
Soil not completely removed
after self-cleaning cycle is
completed
• Failure to clean bottom, from top of oven, frame of oven or door area outside
oven seal. These areas are not in the self-cleaning area, but get hot enough
to burn on residue. Clean these areas before the self-cleaning cycle is started.
Burned on residue can be cleaned with a stiff nylon brush and water or a nylon
scrubber. Be careful not to damage the oven gasket.
• Excessive spillovers in oven. Set the self-clean cycle for longer cleaning time.
Oven smokes excessively during
broiling
• Control not set properly. Follow broiling instructions under Lower Oven
Operating Instructions.
• Meat too close to the broil element. Reposition the broil rack to provide proper
clearance between the meat & the element. Preheat the broil element for
searing.
• Meat not properly prepared. Remove excess fat from meat. Cut remaining
fatty edges to prevent curling, but do not cut into lean.
• Insert on broiler pan wrong side up & grease not draining. Always place grid
on the broiler pan with ribs up & slots down to allow grease to drip into pan
(some models).
• Grease has built up on oven surfaces. Regular cleaning is necessary when
broiling frequently. Old grease or food spatters cause excessive smoking.
Oven control panel beeps &
displays any F code error (for
example F10)
• Oven control has detected a fault or error condition. Press STOP to clear the
display & stop beeping. Try the bake or broil feature again. If the F code error
repeats, remove power supply to appliance, wait 5 minutes and then repower
the appliance and set clock for the time of day. Try the bake or broil feature
again. If the fault recurs, record fault and call for service.
Poor baking results • Many factors aff ect baking results. Make sure the proper oven rack position is
used. Center food in the oven and space pans to allow air to circulate. Allow
the oven to preheat to the set temperature before placing food in the oven.
Try adjusting the recipe’s recommended temperature or baking time. If you
feel the oven is too hot or cool, see “Adjusting Oven Temperature” in the User
Preferences section of this Use & Care Guide.
Before You Call (continued)
Solutions to Common Problems