Filter
Top Products
Setting the Clock
FEATURE OVERVIEW
Setting the Clock
Changing between 12 or
24 hour display
Setting the Clock
The CLOCK (_ pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been
preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply to the range has been
interrupted, the timer in the display will flash with "PF" (power
failure, See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30):
1. Press (_). "CLO" will appear in the display (Fig. 2).
2. Press O _ @ pads to set the time of day to 1:30
(Fig. 3). "CLO" will appear in the display. Press (_.
"CLO" will disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold (_) for 6 seconds (Fig. 3). While holding
the pad down the current time of day will remain and "CLO"
will disappear from the display (Fig. 4). CONTINUE holding
the pad until a beep is heard.
2. The display wilt show either "12Hr"(Fig. 5) or "24Hr"(Fig. 6).
3. Press _ to switch between the 12 and 24 hour time of
day display. The display will show either "12Hr" (Fig. 5) or
"24Hr" (Fig. 6).
4. Press (_ to accept the desired change or press _ to
reject the change.
. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
PRESS
O
OG)Q
Q for 6 seconds
Fig. 1
DISPLAY
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
17