Kenmore 88762 Microwave Oven User Manual


 
PROGRAMMED DEFROST
The power levels for defrosting are predetermined and programrrred into this oven. The oven willdefrost at "HI" power
for the beginning of the chosen time and at power level 30 for the remaining period of time.
1. Touch CLEAR.
2. Touch PROGRAMMED DEFROST. The light below
PROGRAMMED DEFROST will go on and "0" will
show in the display window.
3. Set the defrosting time by following the "programmed
Defrosting Chart" on Pages 22 through 25.
4. Touch START..The oven will begin and the time will
begin counting down in the display window. A tone will
sound when the time is over and the oven will shut
itself off.
NOTE: If you plan to use additional cooking stages
immediately following Programmed Defrost cycles, you
must allow for standing time as recommended on the
Programmed Defrosting Charts on Pages 22 through 25.
This can be accomplished as follows:
I. Touch PROGRAMMED DEFROST and enter the
defrosting time.
2. Touch MEMORY/RECALL.
3. Touch TIME.
4. Enter standing time per charts (Pages 22 thru 25).
5. Touch POWER CONTROL.
6. Enter "0."
7. Touch MEMORY/RECALL
8. Set the next cooking stage per cookbook or USE and
CARE INSTRUCTIONS.
The cooking process can be set for up to 3 stages when
Programmed Defrost is one of the stages.
EXAMPLE: To defrost two pounds of ground beef, use
the PROGRAMMED DEFROST cycle for 9 minutes.
1. Touch CLEAR.
2. Touch PROGRAMMED DE-
FROST. The light below PRO-
GRAMMED DEFROST will go
on. The display window will
show "0."
i
E_Dr=nr_n
EE]EIE3EE]
iigE31EEIED
i
.
Set 9 minutes by touching "9,"
"0" and "0." "900" will show in
the display window.
EE3EEgr'_
[!3EDEE!
r-_EiE3_
rzz_r-r_ EEl
4. Touch START. The oven will
begin to operate and time will
begin to count clown in the
display window. A tone will
sound and the word "End" will
show in the display window for
two seconds when time is over
and the oven will shut itself off.
21