Filter
Top Products
Recycle your Vue
®
pack’s plastic cup wherever #5
plastic is accepted. #5 plastic may not be recyclable in
your community today, so please check locally with
your municipality or waste hauler, or visit
www.vuerecycling.com for more information
about recycling your Vue
®
pack’s plastic cup.
Simply follow these simple steps:
Step 1
Once brewing is complete, lift the Handle and carefully
remove the Vue
®
pack by holding the outer rim.
The Vue
®
pack will be HOT after brewing. Use caution when
removing. Allow it to cool completely before handling.
Step 3
Once separated, discard the lid and any attached
filter. Recycle your Vue
®
pack’s plastic cup wherever
#5 plastic is accepted. #5 plastic may not be recyclable
in your community today, so please check locally with
your municipality or waste hauler, or visit
www.vuerecycling.com for more information
about recycling your Vue
®
pack’s plastic cup.
Step 2
Once cool, separate the lid and filter from the cup.
Any filter will adhere to the lid.
SECTION 6
Recycling the Vue
®
Pack’s Plastic Cup
SECTION 7
Troubleshooting
SOLUTION
• Plug brewer into an independent outlet without dimmer control.
• Check to be sure that it is plugged in securely.
• Plug into a different outlet.
• Reset your home’s circuit breaker if necessary.
• Make sure that the Power Button has been turned on and
Touchscreen is illuminated.
• After placing the Vue
®
pack in the Vue
®
pack Holder, make sure the
Handle is pushed down completely and the Touchscreen displays the
beverage options. Select your desired beverage type on the Touchscreen
and follow the brewing instructions in Section 3 (refer to pages 9-15).
• If the Touchscreen indicates “Add Water,” add water to the Water Reservoir
or make sure the Water Reservoir is seated properly in its base.
• If the Touchscreen indicates “Add Water” even after refilling, remove the
Water Reservoir and empty the water. Then thoroughly clean (refer to
page 20). Fill the Water Reservoir to the “MAX FILL” line, return
it to the brewer and ensure it is seated properly in its base.
• The Brew Head may need to be cleaned or the brewer needs to be
de-scaled (refer to pages 20 and 21).
• If you have completed the above procedure two times and this situation
persists, contact Customer Service at 1.866.901.BREW (2739).
• Clean the Brew Head if necessary (refer to page 20).
• The Water Reservoir may have been removed during brewing.
Replace the Water Reservoir and perform cleansing brews
(refer to page 15) without a Vue
®
pack.
• De-scale the brewer (refer to page 21).
• If you have repeated the de-scale procedure on your brewer two times
and it is still only brewing a partial cup, contact Customer Service at
1.866.901.BREW (2739).
• Check to make sure that the “On/Off Time” and/or “Auto Off” settings
have not been set. Please refer to pages 17 and 18 for instructions.
• The water level is low and a full cup cannot be brewed. Add water to
Water Reservoir.
• If the water level is not low, remove the Water Reservoir and empty the
water. Then thoroughly clean (refer to page 20). Fill the Water Reservoir to
the “MAX FILL” line, return it to the brewer and ensure it is seated properly
in its base.
• If power is interrupted to the brewer by unplugging it, or if power is lost,
follow the procedure on page 17 to set the clock.
SITUATION
Brewer does not
have power
Brewer will
not brew
Brewer brews only
a partial cup
Brewer shuts off or
turns on automatically
The Touchscreen
indicates “Add Water”
The time is not displayed
on the Touchscreen
23 22