Filter
Top Products
top grille decorative
panel assembly,
two small screws
and panel side
trim from one
side of the
decorative panel
assembly to allow
insertion of your
---
custom panel. Reassemble the side
trim, screws, and tethers in reverse
order. Reinstall decorative panel
assembly and pull down to secure.
16
If side panels are not used,
. go to Step 17.
If built-in area depth is 25” (63.5 cm)
or more,
side panels can be installed
inside the side trim or attached to the
outside of the side trim:
-
I
24-518”
(62 ;m)
max.
Top view
l Inside side trim piece:
Slide front
edge of routed side panel into trim
piece. Nail rear edge of panel to
support board.
Top view
24-518”
(62 cm)
max.
L
l Outside side trim piece:
Drill 6
equally spaced holes into side trim
piece.
Do Not drill into side of
appliance.
Attach a support board
to trim piece. Nail front and rear
edges of side panel to support
boards. Cover front support board
with a matching panel piece.
Top view
24-
\
\ rear wall
support board
- side panel
side trim
door
If built-in area depth is less than
25” (63.5
cm),
complete side panel
installation according to site
restrictions. (One method is to install
a support nailer on the built-in
opening rear wall. Drill holes into side
trim. Then attach wood support to
trim. Attach side panel to wood
support and support nailer. Cover
wood support with a matching panel
piece.)
17
Open appliance doors and
. remove protective film from
door frame. Recheck water connections
at bottom of refrigerator for leaks.
Attach bottom grille to cabinet with
two screws. Install shelves and bins in
refrigerator and freezer compartments.
18
Set refrigerator and freezer
. compartment controls to the
midpoint between “COLD” and
“COLDEST.” Check that the
compressor is operating properly and
that all five lights are working.
Part No. 2004022
KPtchenAid”
0 1995 KitchenAid.
8 KitchenAid. Registered trademark
HOME APPLIANCES
of KitchenAid.
Prepared by KitchenAid, St. Joseph, Michigan 49085
Printed in U.S.A.