Filter
Top Products
Parts supplied for ins:allation:
l
base grille
l
miscellaneous parts bag
Check l-hat all
part, were nc ludetl
Product/Property Damage
l
Do Not lower the refrigerator
against the shipping base when
removing the shipping base.
l
Do Not remove protective film
until refrigerator is in operating
position.
l
All four leveling legs must
contact the floor to support and
stabilize the full weight of the
refrigerator.
l
Keep cardboard shipping piece
or plywood under refrigerator
until it is installed in operating
position.
Failure to follow these instructions
may cause damage to product olr
floor covering.
1
Remove and save literature
. package and parts bag taped to
refrigerator door. Remove four
brackets (two on each side) attaching
shipping base to refrigerator bottorn.
Do Not remove tape and door
bracing until product is secured in
final location. See Page 3.
Personal Injury Hazard
l
Because of the weight and size of
the refrigerator, two or more
people are required to install it.
l
Most of the refrigerator’s weight
is at the top. Extra care is needed
when moving the refrigerator
to
prevent tipping.
Failure to follow these instructions
could result in personal injury.
3
Place sections of shipping carton
. on the floor when rolling dolly
and refrigerator into the house. Move
refrigerator close to built-in opening.
4
Set*power switc
at top of cabinet
to “OFF” position.
Plug power supply
cord into
grounded outlet.
Install retainer on
grounded outlet using
screw from parts bag.
5
Place top of cardboard
. carton or plywood under
refrigerator. Remove dolly. Open
appliance doors and remove all boxes,
parts packages and packing materials
from refrigerator and freezer
compartments. Do Not remove
protective film.
Move the refrigerator straight back and
evenly into the opening. Check that:
l
copper tubing is not kinked.
l
power supply cord is on top of
refrigerator next to cover.
corner of
I
\
\
Ye
I
l/4” (6 mm)
(6
mm)
compression
union
nut
I I
l/4” (6 mm)
compression
nut
l/4”
(6
mm)
sleeve
Slide a compression nut and sleeve on
open end of each copper line. Use a
copper tubing union to connect both
copper lines.
Do Not overtighten.
Turn water supply valve to “OPEN”
position. Turn refrigerator switch
“ON.” Wait a few minutes. Check
water line connection and water valve
on top of cabinet for leaks. Without
kinking the tubing, carefully place it
back underneath cabinet.
Insert carton corner posts between
strap and refrigerator at side trim
Check that water supply line has
pieces and handles. Carefully tighten
been flushed. See Page 7.
strap making sure side trim and
6
Pull copper line from refrigerator
handles are protected.
.
water valve and copper line from
plumbing forward from underneath
Paae 8
refrigerator. Remove cap from water line.