Filter
Top Products
Built-in opening
requirements &
dimensions
All dimensions +1/8” (3 mm)
-
Personal Injury/Property
Damage Hazard
l Special care should be taken at
all times to prevent refrigerator
from tipping, as it is top heavy.
l A solid soffit or two, 2” x 4” x
32”
(5 cm x 10 cm x 81 cm)
wood boards to cover the width
of the compressor cover are
required above the refrigerator
to prevent tipping during use.
l If solid soffit is more than 1 inch
(2.5 cm) above refrigerator, two
2” x 4” x 32”
(5 cm x 10 cm x
81 cm) wood boards must be
installed on the wall l/4 inch
(6 mm) above the refrigerator
cover. The bottom surface of
the boards should be 84 inches
(213 cm) from floor. Boards
must be long enough to fully
cover width of compressor
cover.
Failure to follow these
instructions could result in
personal injury or property
damage.
The built-in refrigerator can be
installed:
l
recessed in the cabinet opening.
l
at the end of cabinets using a side
panel to enclose the refrigerator side.
Select one method and use
dimensions given. Dimensions shown
provide 0” (0 cm) clearance.
II
II
I
I I (203229
cm) I I
’ ’ above floor. ’ ’
Grounded electrical
outlet location
Grounded electrical
outlet is required.
Install side panel
(optional) support
board on rear wall if
opening depth is 25”
(1 !ZZm)
(64
cm) or more.
-Width
*
Water line location
Water line
must
provide 15-l 00 psi l-1/2”
(103-690 kPa)
(3.8 cm) V
water pressure.
I
I I
, / 11 I
I T
I I
1 (33 cm) -(12.5 cm)
l/2” (12 mm)
hole for plumbing
can be located
anywhere within
- shaded area.
Floor:
Must support refrigerator, l
\
\ \
\
contents, and door panels.
Opening dimensions
Model
36” (91
cm)
42” (106
cm)
48” (122 cm)
Width min.
35-l/2” (90 cm)
41-l /2” (105 cm)
47-l /2” (120 cm)
Height min.
83-l /4” (211.5 cm) 83-l /4” (211.5 cm) 83-l /4” (211.5 cm)
Height max. 84-3/4” (215 cm)
84-3/4” (215 cm)
84-3/4” (215 cm)
Depth min. 23-l /2” (60
cm)
23-l /2” (60 cm)
23-l /2” (60 cm)
Page 3