Filter
Top Products
Filler panel
re uired if -
pane s are less
7
than l/4”
(6 mm) thick.
nylon
/
washers
(discard)
door
handle-
IGcorative
9
panel
. Remove all taDe and door bracinq
If panels are
more than
l/4” (6 mm)
thick, route
panel edges
on all sides.
from refrigerator and freezer doors.
Remove screws attaching handles to
door frames. Discard nylon washers
underneath screws. Slide decorative
door panels into door frames.
If panels are less than l/4” (6 mm)
thick,
install a filler panel between
door and decorative panel.
If panels are more than l/4” (6 mm)
thick,
route panel edges on all sides.
are atigned and teveJ,
lf4~~~s iwsd ta be adjusted
kbr fight or bl or out,
bmen’&e 3/S” (9 mm) hex
hwfid screws in the tap hinge5
# dptws md to be adjusted
up or
down,
loosen the 3/8
(9 rnmi~ hex head screws in
the b&torn hinges.
Adju$t doors. Tighten screws.
ftimk that doors are aligned
and levei.
assembiy
Remove door stop set screw
located in top and bottcvn
hinges using a f-7 4 Tom
wrench.
Hotd door in the desired position
and replrace ~?t crews. I# door
does not clear countertop after
door stop has been adjusted,
countertops may need to be
““mitered.
top grille
14 .
Slide top grille decorative panel
assembly up and off top grille
assembly. Release the two tethers
holding the decorative panel to the
top grille assembly.
Page 9