Filter
Top Products
13
Bowl, white flat beater and white
dough hook may be washed in an
automatic dishwasher. Or, clean
them thoroughly in hot sudsy water
and rinse completely before drying.
Wire whip, burnished dough hook
and burnished flat beater should be
hand washed and dried
immediately. Do not wash wire
whip, burnished dough hook and
burnished flat beater in a
dishwasher. Do not store beaters
on shaft.
Care and Cleaning
Beater to Bowl Clearance
Your stand mixer is adjusted at the factory so that the flat beater just clears the
bottom of the bowl. If for any reason, the flat beater hits the bottom of the
bowl or is too far away from the bowl, clearance can be corrected as follows:
NOTE: Always be sure to unplug
stand mixer before cleaning. Wipe
stand mixer with a soft, damp
cloth. Do not use household/
commercial cleaners. Do not
immerse in water. Wipe off beater
shaft frequently, removing any
residue that may accumulate.
Tilt-Head models
• Unplug stand mixer.
• Lift motor head.
• Turn screw (A) slightly counterclockwise
(left) to raise flat beater or clockwise (right)
to lower flat beater.
• Make adjustment with flat beater, so it just
clears surface of bowl.
If you overadjust the screw, the bowl lock
lever may not lock into place.
Bowl-Lift models
• Unplug stand mixer.
• Place bowl lift handle in down position.
• Turn screw (B) slightly counterclockwise
(left) to lower the bowl (increased beater
clearance) or clockwise (right) to raise the
bowl (reduced beater clearance).
• Make adjustments with flat beater, so it
just clears surface of bowl.
NOTE: When properly adjusted, the flat beater will not strike on bottom or
side of bowl. If beater or wire whip is adjusted too close so that it strikes
bottom of bowl, coating may wear off beater or wires may wear through
on wire whip.
A
B