Filter
Top Products
9
Assembling Your Bowl-Lift Mixer
To Attach Bowl
1. Be sure speed control is OFF and
stand mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Fit bowl supports over locating
pins.
4. Press down on back of bowl
until bowl pin snaps into spring
latch.
5. Raise bowl before mixing.
6. Plug into a grounded 3 prong
outlet.
To Raise Bowl
1. Rotate handle to straight-up
position.
2. Bowl must always be in raised,
locked position when mixing.
To Lower Bowl
1. Rotate handle back and down.
To Remove Bowl
1. Be sure speed control is OFF and
stand mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Remove flat beater, wire whip,
or dough hook.
4. Grasp bowl handle and lift
straight up and off locating pins.
To Attach Flat Beater, Wire Whip,
or Dough Hook
1. Turn speed control to OFF and
unplug.
2. Slip flat beater on beater shaft
and press upward as far as
possible.
3. Turn beater to
right, hooking
beater over
the pin on
shaft.
4. Plug into a grounded 3 prong
outlet.
To Remove Flat Beater, Wire
Whip, Or Dough Hook
1. Turn speed control to OFF and
unplug.
2. Press beater upward as far as
possible and turn left.
3. Pull beater from beater shaft.
Household stand mixer SPEED
Control
Plug into a grounded 3 prong
outlet. Speed control lever should
always to be set on lowest speed
for starting, then gradually moved
to desired higher speed to avoid
splashing ingredients out of bowl.
See “Speed Control Guide” section.
RAISE
PIN
Solid State Speed Control
Off Stir 2 4 6 8 10
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.