Filter
Top Products
2-1
INSTALLATION INFORMATION
GENERAL
IMPORTANT: Observe all governing codes
and ordinances. Failure to meet codes and
ordinances could lead to fire or electrical shock.
Proper installation is your responsibility:
• Contact a qualified installer to insure that the
dishwasher is installed to meet all electrical
and plumbing national and local codes and
ordinances.
• Install the dishwasher as specified in these
instructions.
• Have everything you need to properly install
dishwasher.
• Protect dishwasher and water lines leading
to dishwasher against freezing. Damage from
freezing is not covered by the warranty.
• This dishwasher is manufactured for inside
use only.
• Install and level dishwasher on floor that will
hold the weight, and in an area suitable for its
size and use.
TOOLS AND MATERIAL REQUIRED
Assemble the required tools and parts before
starting installation. Read and follow the in-
structions provided with any tools listed here.
• utility (carton) knife
• pliers
• tape measure
• flat-bladed screwdriver
• #2 phillips screwdriver
• side cutting pliers
• pencil
• sandpaper
• level
• wood cutting board
• adjustable wrench that opens to 1-1/8″
(29 mm)
• 7 mm socket wrench
• 5 mm socket wrench
• 5 mm open end or box end wrench
• electric or hand drill
• 1-1/2″ hole saw
• valve (sized to fit hot water supply line)
with 3/8″ male compression fitting
• protective floor covering
PARTS SUPPLIED
Located in bottom drawer:
• 2 flexible extrusions (for sides)
• 1 flexible extrusion (for top)
• edge protection
• hose clamp, hose-type
• washer
• 2 installation brackets (top)
• drain hose support
• drain hose connector
• 2 hose clamps, wire-type
• 24 #8 phillips wood screws
• toe kick
• custom toe kick mounting bracket
• moisture protection tape