Filter
Top Products
14
Setting Oven Controls
Fig. 1
Changing between continuous bake
setting or 12-Hour Energy Saving feature
The oven control has a factory preset built-in 12 Hour
Energy Saving feature that will turn off the oven if the oven
is left on for more than 12 hours. The control may be
programmed to override this feature to continuously bake.
Example To change between continuous bake
or 12-Hour Energy saving feature:
1. Press and hold Timer Set/Off keypad for 6 seconds.
2. Press Self Clean to toggle between 12 Hour OFF
(Fig. 4) or Stay On (Fig. 5) feature.
3. Press START to accept choice.
Fig. 4
Fig. 5
Setting Clock
When the appliance is first powered up, 12:00 will flash in
the display (See Fig. 1). The time of day must first be set
before operating the oven.
Fig. 2 Fig. 3
Example To set the clock to 1:30:
1. Press Clock Set/Start keypad.
2. Enter 1 3 0 using numeric keypads.
3. Press START.
Important note:
The clock cannot be changed when a Cook Time or Delay
Start feature is active.
Setting Timer
The minute timer allows you to track your cooking times
without interfering with the cooking process. The timer may
be set from 1 minute up to 11 hours and 59 minutes.
Example To set the timer for 5 minutes:
1. Press Timer Set/Off keypad.
2. Enter 5 using numeric keypad.
3. Press START keypad to start timer.
To cancel the timer when active press Timer Set/Off
keypad again.
Important notes:
The timer does not start or stop the cooking process. It
serves as an extra minute timer in the kitchen that will
beep when the set time has run out. The timer may be
used alone or while using any of the other oven functions.
The timer will display hours and minutes until 1 hour
remains. When less than 1 hour remains, the display will
count down in minutes and seconds. Once the timer has
less than 1 minute remaining only seconds will display.
When the timer is active during a cooking process, the
minute timer will show in the display. To view the
information of any other active oven function, press the
keypad once for the other function to view the status.
Setting 12 or 24 hour display mode
The clock display mode allows you to choose between 12
or 24 hr modes. The factory preset clock display mode is
12 hours.
Example To set 12 or 24 hour display mode:
1. Press and hold Clock Set/Start keypad for 6 seconds.
2. Press Self Clean keypad to toggle between 12 Hr
day or 24 Hr day display modes (See Figs. 2 & 3).
3. Press START to accept choice.