Filter
Top Products
10
Standard Burner
Gas tube opening
Gas must flow freely throughout the gas tube opening for the
burner to light properly. Keep this area free of soil and do not
allow spills, food, cleaning agents or any other material to enter
the gas tube opening. Protect it from spillovers by always using a
burner cap.
Burner ports
Check burner flames occasionally for proper size and shape as
shown above. A good flame is blue in color, not yellow. Keep this
area free of soil and do not allow spills, food, cleaning agents or
any other material to enter the burner ports.
TripleTier™ Flame Burner
Standard Burner
T
o Clean:
1. Remove the burner cap from the burner base and clean
according to “General Cleaning” section.
2. Clean the gas tube opening with a damp cloth.
3. Clean clogged burner ports with a straight pin as shown. Do
not enlarge or distort the port. Do not use a wooden
toothpick. If the burner needs to be adjusted, contact a
trained repair specialist.
4. Replace the burner cap, making sure the alignment pins on
the cap are properly aligned with the burner base.
5. Turn on the burner. If the burner does not light, check cap
alignment. If the burner still does not light, do not service the
sealed burner yourself. Contact a trained repair specialist.
A.Burner cap
B.Burner base
C.Alignment pins
D.Igniter
E.Gas tube opening
A.
³⁄₄
" (19.1 mm)
B.
³⁄₈
" (9.53 mm)
C.Burner ports
A
B
D
E
C
BBA
C
A.1-1¹⁄₂" (25-38 mm)
B.Burner ports
A. Incorrect
B. Correct
B
A
A
B