Filter
Top Products
21
Max Cool
The Max Cool feature assists with periods of high refrigerator
use, full grocery loads, or temporarily warm room temperatures.
■ To turn on the Max Cool feature, press the Max Cool button.
When the button is pressed, the icon will blink 3 times and
appear on the display screen.
■ To manually turn off the Max Cool feature, press the Max
Cool button and the display will blink 3 times and turn off.
The Max Cool feature will remain ON for 24 hours unless
manually turned off. Adjusting the refrigerator temperature will
automatically turn off the Max Cool feature.
NOTE: Setting the freezer to a colder temperature may make
some foods, such as ice cream, harder.
Max Ice
The Max Ice feature assists with increasing the cooling for the
freezer compartment in order to increase ice production.
■ To turn on or off the Max Ice feature, press the Max Ice
button. When the button is pressed to turn the feature on, the
icon will blink 3 times and appear on the display screen.
■ To manually turn off the Max Ice feature, press the Max Ice
button and the display will blink 3 times and turn off. The
Max Ice feature will remain ON for 24 hours unless manually
turned off. Adjusting the freezer temperature will automatically
turn off the Max Ice feature.
NOTE: Setting the freezer to a colder temperature may make
some foods, such as ice cream, harder.
Water Filter Reset
Displays the status of the water filter. To reset the water filter,
press MAX ICE and MAX COOL for 3 seconds. After countdown,
the Good icon will blink 3 times and remain lit.
NOTE: The water filter status lights on the internal controls will
let you know when to change your water filter.
■ ORDER FILTER (Yellow) — Order a replacement water filter.
■ REPLACE FILTER (Red) — Replace the water filter. While you
are dispensing water, Replace Filter icon will flash constantly
from beginning to the end of dispensing. After 14 days
without replacing the Water Filter, the Replace Filter icon will
blink 7 times and an alert tone will sound 3 times, at the end
of dispensing. See “Water Filtration System” section.
NOTE: REPLACE FILTER will remain illuminated if a filter reset
is not done.
■ RESET FILTER — Touch MAX ICE and MAX COOL at the
same time on the temperature control display for 3 seconds
to reset water filter. The display will do a 3-second countdown
and then flash the icon and play a tone.
Energy Saver
Your refrigerator will turn off the vertical mullion heater and
dispenser heater when Energy Saver is enabled.
■ To turn Energy Saver on, press and hold the Energy Saver
button for 3 seconds. The Energy Saver icon will blink 3 times
and then remain lit as shown.
IMPORTANT: When Energy Saver is enabled and the LED is ON,
the dispenser heater and vertical mullion heater will be turned off.
■ Press and hold ENERGY SAVER for 3 seconds again to turn
the heaters back on.
Sound On/Off
The Sound button allows the customer to turn the sound on
and off.
■ To turn on the Sound feature, press the Sound button. When
the button is pressed, the Sound icon will blink 3 times and
appear on the display screen.
■ To manually turn off the Sound feature, press the Sound
button and the display will blink 3 times and turn off.
Power Outage
The Power Outage indicator lets you know if the power supply
to the refrigerator has been OFF and the freezer temperature has
risen.
The control panel display will read “Power Outage” and an alert
tone will sound 3 times. Touch any button to stop the tone and
turn off the Power Outage icon.
Once the power outage has been confirmed, “Power Outage,”
will disappear.
Showroom Mode
This mode is used when the refrigerator is on display in a retail
store or if you want to turn the cooling off and deactivates all
other functions except interior lighting). Showroom mode can be
used when going on vacation, see “Vacation and Moving Care”
section for proper steps on leaving your refrigerator in this mode
for long periods of time.
If you turn on Showroom mode, the word “Showroom” will light
up on the display. Enter or Exit Showroom mode by pressing and
holding °F/°C and DRAWER at the same time for 3 seconds.
NOTE: Empty ice maker if refrigerator is going to be turned off for
an extended period of time.
Sabbath Mode
Sabbath mode is designed to have all the benefits of saving even
more energy, yet maintaining food freshness. The freezer and
refrigerator user set points remain unchanged while in this mode.
If you unintentionally turn on Sabbath mode, the word “Sabbath”
will light up on the display. Enter and exit Sabbath mode by
pressing and holding °F/°C and SOUND at the same time for
3 seconds.
NOTE: You will be unable to dispense or change temperature set
points in Sabbath mode. Your interior lighting and control panels
will all be inactive in Sabbath mode.
External Dispenser Controls
The Dispenser UI is located above the external dispenser of the
refrigerator.
IMPORTANT: The display screen on the dispenser control panel
will turn off automatically and enter “sleep” mode when the
control buttons and dispenser paddles have not been used for
2 minutes or more. Touch any control button to reactivate the
display screen.