Filter
Top Products
7 FINAL CHECK LIST
Open the dishwasher door and remove all cardboard, and literature. DO NOT remove the white plastic plug buttons
(Fig. 17) from the sides of door or the white plastic bumpers on front corners of the lower rack. DO NOT remove the
two
spring retainers (Fig. 18) attached to the tank water heater if dishwasher is so equipped. Close dishwasher door
Remove protective film from the door and lower panel trim areas.
Fig. 17
Turn on the electrical power supply.
Fig. 18
Test dishwasher operation:
1.
Push button models - Close and latch the door. Press Cancel Cycle button, timer will automatically advance
to off. Lift the door handle and allow several seconds for the timer to reset. Latch the door handle, press
Nofmd
Wash button, and allow the dishwasher to run through a complete cycle.
2. Cycle Selection Dial Models - Close and latch the door, Turn the dial clockwise until it clicks into the
NOma/
Wash position. Press Start or Normal Wash button and allow the dishwasher to run through a complete
Cycle.
3. So/id State Models - Close and latch door. PF appears in display. Press Cancel.
Turn off the electrical power and check for leaks
under the dishwasher. Make sure that no kinks
have developed in the fill or drain lines.
The lower panel and adjustable kickboard (Fig. 19)
must be replaced. Line up panel flanges (3) to fit
under lip of channel (4). Slide panel up until it
stops and then push up tabs (2) to hook over the
frame. Secure the lower panel with two screws (1).
Replace the kickboard using two screws (one with
lock washer). Check to assure that the opening
at the bottom of the kickboard is not obstructed
2
(e.g., by carpet, molding, etc.). This area must be
open to provide air circulation to cool the motor.
This completes dishwasher installation. For more
information about the dishwasher, please refer
to your Use and Care Guide.
klckboard
Fig. 19
- 12 -